UFP Hub W/ 5 on 4.5" Bolt Pattern For 3,700lb Axles
There is no need to worry about the races as they are already pressed into the hub for you. This hub is designed for use with a #84 spindle. The bearings, seal, caps, wheel nuts, and spindle hardware sold separately.
• Hub only(will not fit standard Dexter, Al-ko, Lippert, Rockwell 3.5K axles)
• Hub only
• 5 on 4.5" Bolt pattern
• 1 L44610 Outer Race (Already Pressed In) 1.98" OD
• 1 L68111 Inner Race (Already Pressed In) 2.361" OD
• Uses L68149(1.378" ID) and L44649(1.063" ID) bearings(sold separately)
• Uses 168255TB seal(Please verify dimensions before purchase of seal. Some older hubs use a seal with a slightly smaller OD.)
• Uses caps with a 1.980" outer bore
To determine the bolt circle on hubs or wheels with an odd number of bolt holes, measure from outside to center of the studs across the pattern(bolt patterns are always measured in inches). Example: If you were to number the studs 1, 2, 3, then you would measure from the outside of stud 1 to the center of stud 3.