Dexter Hub W/ 5 on 4.5" Bolt Pattern For 2-2.2k Axles W/8-12" Wheels
There is no need to worry about the races as they are already pressed into the hub for you. This hub is designed for use with a BT8 or BTR spindle. Each hub has a capacity of 1,000lbs using the L44643 bearings and 1,100lbs using the L44649 bearings. The bearings, grease seal, grease cap, wheel nuts, spindle nut, and spindle washer sold separately. Kit with hardware is available.
• Hub only
• 5 on 4.5" Bolt pattern
• 1 L44610 Outer Race (Already Pressed In) 1.98" OD
• 1 L44610 Inner Race (Already Pressed In) 1.98" OD
• Uses L44643(1" ID) or L44649(1.063" ID) bearings(sold separately)
• Use with 8-12" wheels
• 4" Overall height
To determine the bolt circle on hubs or wheels with an odd number of bolt holes, measure from outside to center of the studs across the pattern(bolt patterns are always measured in inches). Example: If you were to number the studs 1, 2, 3, then you would measure from the outside of stud 1 to the center of stud 3.